Getting Started
Accessory
List
• Head unit , 1
• Power Cable 1
•
Pre
OUT/AUX cable 1
• iPod Video FULL
SPEEDTM
Connection Cable 1
• Mounting Sleeve 1
• Mounting Bracket
.2
• Flush Head screw (M4 x 3) 8
• Hexagon washer-head screw (M4 x 6) 4
• Front Frame . 1
• Remote Control ,.....................
..
1
• Battery (CR2025)
..
1
• Carrying bag . 1
• Owner's Manual 1 set
Connectable
to
Remote Control Interface Box
You
can operate this unit from the vehicle's control unit when an
Alpine Remote Control Interface Box (optional)
is
connected. For
details. contact your Alpine dealer.
Location
01
Controls
CD
Rotary encoderIMUTE/AUDIO
Adjust the volume by turning to the left or right.
Press the Mute mode on or off by pressing repeatedly.
If
pressed and held for at least 2 seconds, the audio setup
screen
is
displayed.
® SOURCE/c!> button
Turns the power on. Press and hold for at least 2 seconds to
turn the power off.
Monitor open: Recalls the SOURCE selection screen.
Monitor closed: Changes the source.
lO-EN
@ BANDISAT button
Radio mode: Changes the band.
Visual source (except navigation screen): Changes the
display mode.
Press this button for at least 2 seconds
to
recall a weather
channel or traffic channel. Note however, this setting can be
made only if the
XM
or SIRIUS Receiver Box
is
connected.
@ Remote Sensor
Point the supplied remote control transmitter towards the
remote sensor within a range of 2 meters.
® VISUAL button
Press and hold for at least 2 seconds
to
recall the VISUAL
selection screen.
If VISUAL is set
in
"Setting the VISUAL Button" (page 39),
momentarily press to recall the VISUAL selection screen,
and if
NAV.
is
set, momentarily press to recall the navigation
screen.
@ OPEN/CLOSE/FLAT button
Opens the monitor.
Closes the monitor
by
pressing and holding for at least 2
seconds.
Press to set the open monitor to the flat position.
CJ)
~
button
Ejects a disc.
®
~button
Use this button
to
remove the front panel.
® DISC IN Indicator
Lights
up
when a disc is inserted
in
the unit.
@ Power Indicator
This indicator is lit when power is on.
• The buttons
on
theface
of
this unit are shown
in
bold
(e.g.
SOURCE/c!».
The onscreen buttons that appear
in
the display
are shown
in
bold enclosed by [ J
(e.g.
[BAND]).
To Next Page
Loading...
