New
Discs
To prevent the
CD
from jamming, "DISC ERROR"
is
displayed
if
discs with irregular surfaces are inserted or
if
discs are inserted
incorrectly. When a new disc
is
ejected immediately after initial
loading, use your finger to feel around the inside
of
the center hole
and outside edge
of
the disc.
If
you feel any small bumps
or
irregularities, this could inhibit proper loading
of
the disc.
To
remove the bumps, rub the inside edge
of
the hole and outside edge
of
the disc with a ballpoint pen or other such instrument, then insert
the disc again.
~
PRECAUTIONS
Product
Cleaning
Use a soft dry cloth for periodic cleaning
of
the product. For more
severe stains, please dampen the cloth with water only. Anything
else has the chance
of
dissolving the paint or damaging the plastic.
Temperature
Be sure the temperature inside the vehicle
is
between +45°C
(+1
13°F) and
QOC
(+32°F) before turning your unit on.
Moisture
Condensation
You
may notice the disc playback sound wavering due to
condensation.
If
this happens, remove the disc from the player and
wait about an hour for the moisture to evaporate.
~
cente, Hole
Bumps
cente,~~_
/
N_
0'"
~
".
Outside
(Bumps)
Damaged
Disc
Do not attempt to play cracked, warped, or damaged discs. Playing
a bad disc could severely damage the playback mechanism.
Maintenance
If you have problems,
do
not attempt to repair the unit yourself.
Return it to your Alpine dealer
or
the nearest Alpine Service
Station for servicing.
Installation
Location
Make sure the IVA-DI06 will not be installed in a location
subjected to:
• Direct sun and heat
• High humidity and water
• Excessive dust
• Excessive vibrations
CORRECT
Correct
Handling
Do not drop the disc while handling. Hold the disc so you will not
leave fingerprints on the surface. Do not affix tape, paper,
or
gummed labels to the disc.
Do
not write on the disc.
o
M
CORRECT
INCORRECT
Never
Attempt
the
Following
Do not grip or pull out the disc while
it
is
being pulled back into the
player
by
the automatic reloading mechanism.
Do not attempt to insert a disc into the unit when the unit power
is
off.
Inserting
Discs
Your player accepts only one disc at a time for playback. Do not
attempt
to
load more than one disc.
Make sure the label side is facing up when you insert the disc.
"DISC ERROR" will be displayed on your player
if
you insert a
disc incorrectly.
If
"DISC ERROR" continues to be displayed even
though the disc has been inserted correctly, push the RESET switch
with a pointed object such as a ballpoint pen.
Playing a disc while driving on a very bumpy road may result in
skips, but this will not scratch the disc or damage the player.
Irregular
Shaped
Discs
Be sure to use round shaped discs only for this unit and never use
any special shaped discs.
Use
of
special shaped discs may cause damage to the mechanism.
o
~
Disc
Cleaning
Fingerprints, dust, or soil on the surface
of
the disc could cause the
DVD player to skip. For routine cleaning, wipe the playing surface
with a clean, soft cloth from the center
of
the disc to the outer edge.
If
the surface
is
heavily soiled, dampen a clean, soft cloth in a
solution
of
mild neutral detergent before cleaning the disc.
6-EN
To Next Page
Loading...
