Radio
Display
example
for
FM
Radio
main
screen
CD
Displays
the preset number/frequency.
This unit cannot receive HD Radio signals (digital terrestrial
radio).
In
order
to
activate the digital radio functions
described below,
an
optional
HD
Radio Tuner module must
be connected through the Ai-NET bus.
Listening
to
the
Radio
1 Touch
[SOURCE]
on the main source screen.
The SOURCE selection screen is displayed.
Receiving Analog Radio:
2 Touch
[RADIO].
The radio mode is activated and the display changes to the
Radio Mode screen.
Receiving HD Radio (if TUA-T500HD is connected):
2 Touch
[HD
RADIO].
The digital radio mode is activated and the display changes
to the
HD
Radio Tuner Mode screen.
3 Touch
[BAND]
to select the desired radio band.
Each press changes the bands
as
follows:
FM-1
~
FM-2
~
AM
~
FM-1
4 Touch
[TUNE]
to choose the tuning mode.
Each touch changes the tuning mode display.
Distance
~
Local
~
Manual
~
Distance
• There are two modes you can select
for
auto tuning, DX and
Local:
DX (Distance) mode (with DX SEEK indicator ON);
Both strong and weak stations will be limed
in.
Local mode (with SEEK indicator ON);
Only strong stations will be tuned
in.
The initial setting
is
DK
5 Touch
[~],
[~]or[~],
[~]to
change
the
radio frequency up or down respectively.
In
the manual mode, touch and hold to change the
frequency continuously.
• "DIGITAL"
is
displayed when a digital radio station is received.
• Also refer to "Digital SEEK Setting (HD Radio mode only)"
(page 35).
14-EN
Manual
Storing
of
Station
Presets
1 Tune
in
a desired radio station you wish to store in
the preset memory by manual or automatic seek
tuning.
2 Touch
[P1/2]*
to change the function guide.
* "[P1I3j" is displayed in the HD Radio mode.
3 Touch and hold
anyone
of the preset buttons
[P.SET
1]
through
[P.SET
6]
for at least 2 seconds.
The selected station is stored.
4 Repeat the procedure to store up to 5 other stations
onto the same band.
To
use this procedure for other bands, simply select the
band desired and repeat the procedure.
A total of 18 stations can be stored
in
the preset memory (6
stations for each band:
FM1,
FM2
and AM).
•
If
a preset memory has already been set in the same preset number, it
will be cleared and the new station will be memorized.
Automatic
Memory
of
Station
Presets
The tuner can automatically seek and store 6 strong stations
in
the
selected band
in
order
of
signal strength.
After selecting the desired band, touch
[A.MEMO].
The tuner automatically seeks and stores 6 strong stations into
[P.SET
1)
to
[P.SET
6)
in
order of signal strength.
When the automatic storing has been completed, the tuner goes
to the station stored
in
[P.SET
1).
•
If
no stations are stored. the tuner will return to the original station
you were listening to before the automatic storing procedure began.
Tuning
to
Preset
Stations
You
can tune in the preset stations
in
memory on each band using the
preset number.
1 After selecting the desired band, touch
[P1/2]*
to
change the function guide.
* "[P1I3j" is displayed
in
the HD Radio mode.
2 Touch
anyone
of the preset buttons
[P.SET
1]
through
[P.SET
6]
that has a station stored to it.
The preset station
is
received.
To Next Page
Loading...
