Adjusting
the
volume
when
receiving
a
Call
While calling, you can adjust the volume. The adjusted
volume level is stored.
Turn the
Rotary
encoder
or the Double
Action
encoder
to adjust the volume.
•
You
may need to increase volume from your regular audio
listening source level. However, increasing the volume
excessively may result in feedback.
If
feedback
is
noticed as
feedback is directly related to the volume, turn down the
volume as low as acceptable to eliminate
it.
Positioning the
microphone
in
a direction awayfrom the main car speakers
(e.g. clipped on sun visor) may also reduce feedback at
high volume.
Redial
Function
You
can redial the person you have previously called.
After finishing a call, press
",/
or \.. within 5
seconds.
The telephone
is
redialed.
Audio
Switching
Operation
(CD
Head
Don
Only)
While making a call, this function allows you
to
initiate the
transfer
of
the audio between the mobile phone and the
speakers
in
the car.
While calling, press and hold
ENT
for at least 2
seconds to switch the call sound between the
speakers
in
car and mobile phone.
• Depending on the mobile phone, this operation may not be
peiformed.
Call
History
Call History
is
recorded for the last dialed/received/missed
calls. There are various ways
of
making calls based on the
"Call History." The following steps 1
to
4 are common to the
various ways
of
making these calls. For details, refer to each
individual category for making calls.
t Press",/ or
\...
The outgoing method list
is
displayed.
2 Turn the
Rotary
encoder
or the Double
Action
encoder
to select the outgoing
mode.
Setting items : DIALED / RECEIVED / MISSED /
PHONE BOOK
DIALED : Dialed history
RECEIVED : Received history
MISSED : Missed incoming history
PHONE BOOK : Mobile phonebook
• The adapter will update the information
in
the Call History
automatically each time a mobile phone is connected
or
receiving/dialing a call.
At
this time, ifyou select any
outgoing mode, "UPDATING" will be displayed.
3
PressENT.
The outgoing mode
is
activated, and each mode
list is displayed.
• It may take some time
for
the list to be displayed, and also
directly after connection, the list may not be brought up to
date.
4 Turn the
Rotary
encoder
or the Double
Action
encoder
to select a name or a
telephone number from the list.
5
PressENT.
The selected telephone will be called.
If
one name has several numbers registered
in
the
telephone book for CD Head Unit, press
ENT after
selecting the name*, then turn the Rotary encoder
to choose the desired number and press ENT, the
telephone will be called. Press and hold
ENT for at
least 2 seconds after selecting the name, the
default number of the name will be called.
Depending on the connected mobile phone, this
function may not be performed. (Only for CD Head
Unit)
*
If
the name cannot be recognized, default number will be
displayed.
•
If
you place a call directly from the paired mobile phone,
the phone number is not displayed, you cannot redialfrom
the unit in this case.
7.EN
I
To Next Page
Loading...