Alpine NVE-M300P - Selecting Intersection as Destination

NVE-M300P Navigation Module Owner’s Manual
32
• Tap
to open the list of results before it appears automatically.
3. Instead of selecting one of the streets, tap
.
5. Enter the house number:
1. Enter the house number on the keyboard.
2. Tap
to finish entering the address.
6. A list appears with the matching addresses. Tap the desired one.
7. The map appears with the selected point in the middle. Tap
. The route is
then automatically calculated, and you can start navigating.
7.1.2.4 Selecting an intersection as the destination
1. Tap the following buttons: , , .
2. By default, Alpine Navigation Software proposes the country/state and settlement where you
are. If needed, tap the button with the name of the country/state, and select a different one
from the list.
3. If needed, change the settlement:
• To select the settlement from the list of recently used ones, tap the
button.
• To enter a new settlement:
1. Tap the button with the name of the settlement, or if you have changed the
country/state, tap
.
2. Start entering the settlement name on the keyboard.
3. Get to the list of search results:
• After entering a couple of characters, the names that match the string
appear in a list.
• Tap
to open the list of results before it appears
automatically.
4. Select the settlement from the list.
4. Enter the street name:
1. Start entering the street name on the keyboard.
2. Get to the list of results:
• After entering a couple of characters, the names that match the string appear in a
list.
• Tap
to open the list of results before it appears automatically.
3. Select the street from the list.