Alpine NVE-M300P - Route Planning Options; These Settings Determine How Routes will be Calculated

NVE-M300P Navigation Module Owner’s Manual
61
8.5.3 Route Planning options
These settings determine how routes will be calculated.
Tap the following buttons:
, , .
Button Description
Vehicle You can set the type of vehicle you will use to navigate the route.
Based upon this setting, some of the road types
can be excluded from
the route
or some of the restrictions may not be taken into account in
route calculation.
Road Types Used for Route
Planning
To let the route fit your needs, you can also set which road types ar
e
to be considered for or to be excluded from the route if possible.
Excluding a road type is a preference.
It does not necessarily mean
total prohibition. If your destination
can only be accessed using some
of the excluded road types, they will be used bu
t only as much as
necessary. In this case a warning icon will be shown on the
Route
Information
screen, and the part of the route not matching your
preference will be displayed in a different colour on the map.
Route Calculation Method
You can choose from different route types.
The routing method can be
changed temporarily while creating the route: when the destination
is
selected, tap in the Cursor menu.
TMC Reroute Method
This setting determines how Alpine Navigation Software uses the
received TMC information in route recalculation:
• Auto: When route recalculation
becomes necessary based on
the received TMC events
, Alpine Navigation Software
recalculates the route automatically.
• Manual: When route recalculation
becomes necessary based
on the received TMC events
, Alpine Navigation Software
notifies you, but you can decide whether to recalculate the
route or not.
• Off: TMC events are only taken into
account when the route is
recalculated in an off-route situation.
Vehicle types:
• Car
• Taxi
• Bus
• Emergency vehicles