Active 3-way mode
LOW MID LOW MID HIGH HIGH
*1 Adjustment cannot be performed when the SUBWOOFER mode is off.
2 Turn the Rotary encoder to select the desired setting item, and then press the Rotary encoder.
Setting the Cut-off Frequency
Active 2-way mode
Setting contents:
20 / 25 / 31.5 / 40 / 50 / 63 / 80 (Initial setting) / 100 / 125 /160 / 200 (Hz)
Active 3-way mode
Setting contents:
LOW/MID LOW*:
20 / 25 / 31.5 / 40 / 50 / 63 / 80 / 100 / 125 / 160 / 200 / 250 / 315 /400 / 500 (Initial setting) / 630 / 800 (Hz)
MID HIGH:
20 / 25 / 31.5 / 40 / 50 / 63 / 80 / 100 / 125 / 160 / 200 / 250 / 315 / 400 / 500 / 630 / 800 / 1 k / 1.2 k / 1.6 k / 2 k / 2.5 k / 3.2 k / 4 k / 5 k (Initial setting) /
6.3 k / 8 k / 10 k / 12.5 k / 16 k / 20 k (Hz)
HIGH:
1 k / 1.2 k / 1.6 k / 2 k /2.5 k / 3.2 k / 4 k / 5 k (Initial setting) / 6.3 k / 8 k / 10 k / 12.5 k / 16 k / 20 k (Hz)
* The cut-off frequency setting of MID LOW should not be more than that of MID HIGH.
Adjusting the Slope
Setting contents:
FLAT* / 6 / 12 (dB/oct.)
* In the 3-way mode, HIGH does not correspond to FLAT.
Note
The initial setting of active 2-way mode is FLAT, and the initial setting of active 3-way mode is 12.
Adjusting the Level
Setting contents:
-12dB~0dB (Initial setting: 0)
When DEFEAT is turned on, the sound effect related settings such as EQ PRESETS will become invalid. Turning DEFEAT off can return to
the previous sound effect setting.
Setting item: DEFEAT Setting
Setting contents: OFF (Initial setting) /ON
Connecting to an External Amplifier
When an external amplifier is connected, sound quality can be improved by stopping the power supply of the built-in amplifier.
Setting item: BUILT-IN AMPLIFIER SWITCH
Setting contents:
OFF / ON (Initial setting)
OFF:
Use this mode when the pre-output of this unit is used to drive an external amplifier. In this setting, the head unit’s internal amplifier
is turned OFF and cannot drive speakers.
ON:
The speakers are driven by the built-in amplifier.
To Next Page
Loading...
