Connecting USB Memory / MTP (Optional)
If you connect a USB memory / MTP device to the unit, it can play MP3/WMA/AAC/WAV/FLAC/APE files.
Playback
1 Press to select USB mode.
2 Touch or to select the desired track (file).
Pressing and holding or will fast backward/fast forward track continuously.
3 To pause playback, press .
Pressing again will resume playback.
Note
• Depending on the file stored in USB/MTP, it may take some time to start playback.
• During playback, the screen will display the format of file played.
• When it plays a high-resolution (Hi-Res) audio file, the screen will display HR icon.
• Any file protected by DRM (Digital Rights Management) copy protection, cannot be played back on this unit.
• The playback time may not be correctly displayed when a VBR (Variable Bit Rate) recorded file is played back.
• If the file contains tag information, the song name / artist name / album name will be displayed.
• The unsupported characters will be replaced with “ ” when displayed.
Repeat Play
1 Press .
The song is played back repeatedly.
*1 Only a track/file is repeatedly played back.
*2 Only files in a folder are repeatedly played back (it works after searching by folder).
*3 Repeat Play is turned off.
2 To cancel Repeat Play, turn off this function by following the above procedure.
Searching for a desired Song
A USB memory can contain many songs. Search by folder or category to find a desired song rapidly.
1 Press the Rotary encoder to activate the search mode.
2 Turn the Rotary encoder to select “Searching by folder” or Searching by category”, and press the Rotary encoder.
To Next Page
Loading...
