Using the Controller Bracket for Installation
Set the installation location.
• Check whether the supplied cable is long enough. Install this unit at a location free from water.
Do not install the unit or wiring at the locations that hinder driving or airbag.
• Console or dashboard, etc
* Before installation, remove the assembly on which this product will be installed.
1 Attach the light shield ⑤ onto backside of the controller. Align with the two holes.
2 Align the locking posts on the adjusting base of bracket ③ with the mounting holes on the controller, and press the base until it is secured.
3 Then affix the bracket onto the console or dashboard, etc.
To Next Page
Loading...
