① Rear USB Cable (Supplied)
Connect it to USB Memory/MTP (mobile phone) or iPod/iPhone. Use Lighting to USB cable if an iPod/iPhone is connected.
Notes
• Please use the supplied USB cable. Normal performance cannot be guaranteed if a USB cable other than the supplied one is used.
• Keep the USB cable away from other cables.
② Controller Cable (Supplied)
③ Power Antenna Lead
Connect this lead to the +B terminal of your power antenna, if applicable.
Note
• This lead should be used only for controlling the vehicle’s power antenna. Do not use this lead to turn on an amplifier or a signal
processor, etc.
④ Remote Turn-on Lead (Blue/White)
Connect this lead to the remote turn-on lead of your amplifier or signal processor.
⑤ Illumination Lead (Orange)
This lead may be connected to the vehicle’s instrument cluster illumination lead. This will allow the backlighting of this unit to dim
whenever the vehicle’s lights are turned on.
⑥ Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or another unused power source which provides (+) 12V only when the
ignition is turned on or in the accessory position.
⑦ Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
⑧ Fuse Holder (15A)
⑨ Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using
the metal screw provided.
⑩ Front Right (+) Speaker Output Lead (Grey)
⑪ Front Right (−) Speaker Output Lead (Grey/Black)
⑫ Rear Right (−) Speaker Output Lead (Purple/Black)
⑬ Rear Right (+) Speaker Output Lead (Purple)
⑭ Rear Left (+) Speaker Output Lead (Green)
⑮ Rear Left (−) Speaker Output Lead (Green/Black)
⑯ Front Left (−) Speaker Output Lead (White/Black)
⑰ Front Left (+) Speaker Output Lead (White)
⑱ Controller Connection Terminal
⑲ Steering Remote Control Interface Connector
To steering remote control interface box.
For details, contact your Alpine dealer.
⑳ MIC Input Connector
To Microphone.
㉑ Rear USB Terminal
Use the supplied USB cable to connect it to the unit compatible iPod/iPhone or USB Memory/MTP (mobile phone).
To Next Page
Loading...
