5
ASSEMBLING & USING YOUR PRODUCT
3. Locate the vinyl tubing under the Fountain and connect it to the
tube connector on the Pump.
4. Pour 32 oz. of water into the Fountain Base. Do not overow as
this may cause splashing. Make sure the pump is completely
submerged and the water runs clear during operation.
NOTE: We recommend using distilled water to prevent scale build-
up. It can take up to 5 minutes for the air to be completely expelled
and water begins to ow the rst time you operate the pump.
Alpine Quick Tip #2
The black tube connector
may be attached to the vinyl
tubing or the pump depending
on the product. It is shown
attached to the pump here.
To Next Page
Loading...
