17-EN
01GB05X009E.fm
ALPINE X009E 68-24567Z66-A (EN)
Accessory List
• X009E ..................................................................................1
• GPS Antenna .......................................................................1
• Antenna mounting plate ......................................................1
• Cable clamp for antenna................................................1set
• AUX/PRE OUT cable ...........................................................1
• CAMERA/W.REMOTE cable ................................................1
• USB extension cable ...........................................................1
• Cushion................................................................................1
• Screw (M5×8)......................................................................8
• Owner’s Manual..............................................................1set
Location of Controls
For Alphard/Vellfire
For Estima
(My Favourites) button
The My Favourites screen for registered User1 or User2 is
displayed.
/ (for Alphard/Vellfire) or -/+ (for Estima) button
Press to adjust the volume.
MUTE (for Alphard/Vellfire) or (for Estima) button
Press to activate/deactivate the mute mode.
Press and hold this button for at least 3 seconds to turn the
power off.
(AUDIO) button
Displays the Audio/Visual screen. If the Audio/Visual screen
is already displayed, changes the source.
Press and hold this button for at least 3 seconds to activate
the “Easy Sound Setup” mode (page 23). You can select
this menu to be displayed on the left or right of the screen.
For details, refer to “Setting the Easy Sound Setup Position”
(page 49).
button
Recalls the navigation map screen.
Press again to switch to Navigation menu screen.
Press and hold this button for at least 3 seconds to change
to Go Home route screen. If the Home is not set yet, it will
change to Home setting screen.
For details of navigation operations, refer to “Navigation
System OM”.
(PHONE) button
Recalls the Telephone Menu screen.
When a hands-free phone with Voice Recognition is
connected, press and hold for at least 3 seconds to switch
to the Voice Recognition mode.
Dimmer Sensor/Remote Sensor
• Sense the brightness of the car interior.
• Point the remote control transmitter towards the remote
sensor within a range of 2 metres.
c (Eject) button
Turning Power On or Off
Some of this unit’s functions cannot be performed while the vehicle is in
motion. Be sure to stop your vehicle in a safe location and apply the
parking brake, before attempting these operations.
1
Turn the ignition key to the ACC or ON position.
The system turns on.
• When turned on, the system displays the last mode screen that
was displayed before the ignition key was turned off. For
example, if the unit is in radio mode when ignition is turned off,
it will remain in radio mode when ignition is turned back on.
2
Press and hold the MUTE*
1
(or )*
2
button for at
least 3 seconds to turn the power off.
*
1
For Alphard/Vellfire
*
2
For Estima
• The unit can be turned on by pressing any button.
• The X009E is a precision device. Careful handling of the unit should
provide you with years of trouble-free operation.
Getting Started
• This is only an example illustration, about the name and
layout of buttons, please refer to your vehicle.
Optional Remote Control Interface Box
This unit is operable using the vehicle’s secondary radio controls.
An Remote Control Interface Box (optional) is required. For details,
contact your dealer.
Controllable with Remote Control
This unit can be controlled with an optional remote control. For
details, consult your dealer. Point the optional remote control
transmitter at the remote control sensor.
About the button descriptions used in this Owner’s
Manual
The buttons found on the face of the unit are expressed in
bold (e.g. (My Favourites)). The buttons found on the
touch-screen display are shown in bold within brackets, [ ]
(e.g. []).
01GB00X009E.book Page 17 Friday, May 9, 2014 1:16 PM
To Next Page
Loading...
