22
VOICE MESSAGE ACTIVATION. The Voice messages can be activated by either:
-Manually from the bar menu option.
-At a programmed time from the Schedule Task option menu.
-Externally from a logic input connection (GPIO options). See GPIO configuration menu.
-From the Remote control and IR control. See Remote Control configuration menu.
7.3 SPECIAL OPERATIONS. MEMORY – PRESETS – SETUP
The Map processor operates with parameters as master level, preamp gain, EQ curves, etc. that are the
actual parameters that defines the audio behaviour. We define the whole set of these parameters as the
WORKING MEMORY. The working memory is then saved as presets when needed.
When the MAP shuts down, the working memory is not lost and is used on the next switch ON to operate
the device.
The working memory can be changed from the 3cMAP user, remote controls, gpio or schedules so it is
necessary a first time store on the internal memory or outside in the PC for future recalls.
The MAP processor can store internally up to 10 named presets and externally on the PC drives as
backup organized in files and directories.
A preset loaded from the PC would transfer parameters to the working memory for operate the unit but it
is not automatically stored on any of the 1 to 10 internal presets. Save it on presets if necessary.
The Remote Control parameters are stored on the remote devices it shelves and not in the MAP
processor nor in the PC presets.
The list of
schedules tasks
and the
GPIO definitions
are stored in the MAP only and are not stored in the
presets nor in the PC presets.
The action of the
voice message
is only stored on presets with the condition that the preset is stored at
the moment it is played and the repeat function is enabled (checked).
7.4 MAP FIRMWARE UPDATES
The MAP processor firmware and the 3cMAP version could be updated from the internet.
In order to manage an automatic check for updates, check the appropriate option “Check for updates”
on the HELP menu from the 3cMAP software.
If you prefer an automatic update, check the appropriate box “Check for updates at start up” on the
HELP menu from the 3cMAP.
The update process checks for new firmware and software revisions for the mcu processor, the dsp
processor on the MAP device and on the 3cMAP sequentially.
To Next Page
Loading...