Altair MAP1216 - 9 Technical Specifications

26
9. TECHNICAL SPECIFICATIONS
DISTORTION
 THD+N < 0,03% @ 0 dBu (25Hz- 50KHz).
FREQUENCY RESPONSE
 20 Hz- 20KHz (-2, -0.5 dB) at +4 dBu input level
NOISE (preamp)
 -124 dBu (EIN) 20 Hz-22KHz, 60 dB gain, 150 ohm
DYNAMIC RANGE
 >104 dB, 0.1% THD, un-weighted (U/W 20-20 KHz)
INPUT IMPEDANCE (mic/line)
 4 K. Electronically balanced.
INPUT LEVEL
 0 dBu nominal / +20 dBu maximum at 0dB gain
INPUT GAIN
 0dB to +60dB, 1 dB step
CROSSTALK (channel to channel)
 Better than 80 dB at 1KHz. (>70 dB from 20 Hz to 20 KHz).
C.M.R.R.
 Typical value: Better than 65 dB at 1KHz.
PHANTOM POWER
 +48Vdc. Individually selected on each input channel
OUTPUT IMPEDANCE
 100. Electronically balanced and floating.
OUTPUT LEVEL
 0 dBu nominal / +20 dBu maximum.
FRONT PANEL INDICATORS
 Input/Output levels: Signal present/nominal/peak.
 Phantom power: Indication on every input individually
 Device Status/ Phantom Power/Communications/Link
COMMUNICATIONS
 USB. Front panel.
 Remote panel units (proprietary). RJ11 6/6 connector
 Ethernet 10/100. RJ45 connector
 Link (proprietary). Dual RJ45 connectors
SOFTWARE CONTROL
 3cMAP for PC/android
A/D and D/A converters
 24 bit
SAMPLING RATE
 48 KHz
INPUT/OUTPUT/GPIO CONNECTIONS
 3 pin Phoenix ™ 3.5 mm Type.
LINE POWER
 Autorange 90 TO 260 VAC, 50-60 Hz.
POWER COMPSUMPTION:
 60 V.A.
DIMENSIONS/WEIGHT:
 483x44x250 mm. (19" x 1U)/6Kg net
NOTE: Specifications subject to change without notice.
MATRIX AUDIO PROCESSOR MAP128 /MAP1216