Altec Lansing 1707C - Page 15

Di ei l
INPUTS 1-6 Fund å
1707C (INPUTS 1-6)
Svstem 1
Link Qut Zone 1 Master
Signal
Flow
INPUTS 7-12 FL
Zone 2
—— (INPUTS 1-12)
——
Svstem 2
Zone 2 Master
INPUTS 1-6 AT-
1707C ——- INPUTS 1-12
System 1 AE
Note: Preamp Out/Amp In jumper removed
in system 1.
Link Out
Link in
INPUTS 7-12
INPUTS 1-12
Master
| Figure 11. Typical Linking Connections
Master E
INPUTS 1-6 $707C !
> E — INPUTS 1-4
Preamp Out Amp ln NE
| Tip Sleeve Tip Sieeve
(| += ag
Signal A |
Flow 2 EŃ
MI Le Cam
A
SP jule
Input Qutput
Externsi
E quallzer/Pracessor
Figure 12. Patching an External Equalizer or
Other Signal Processing Device
AUX OUT Connections
The auxiliary output (AUX OUT) phono con-
nector on the rear panel is wired directly
(internally) to the AMP IN phono connector.
You can use it to drive a second amplifier or a
tape recorder. Please refer to the 1707C/
1715C mixer/power amplifier's block diagram
shown in Figure 7.
Batterv Input Connections
You can power a system from the battery input
connector for auxiliary operation or standby
switchover. The battery input connector is the
three-terminal barrier strip located on the
upper-left rear panel of the mainframe. The
system requires two +48V DC battery power
sources.
To connect the battery backup system to the
three-terminal barrier strip, follow the three
steps shown in Figure 13.
Step O
Remove Cisar Plastic Cover.
Siep (2)
Connect DC Power Sources
ss Shown.
Step (3)
Re-inetail Clear Plastic
Protective Cover.
DC Power Sources
Figure 13. Battery Input Connections