Altech
28
IMPORTANT: Install the water softener on the cold water system (5°C to 20°C).
IMPORTANT: Upstream of the water softener, install the following (in sequence):
- An unsoftened cold water pipe to supply the kitchen tap (not supplied).
- A shut-off valve (not supplied).
- A standard isolator (not supplied).
- The filter with a rating of 20 µm. Change the cartridge regularly,
in accordance with the manufacturer’s instructions (supplied).
- Downstream of the water softener, install a shut-off valve (not supplied).
Install these recommended accessories using standard unions.
CONNECTING THE WATER SOFTENER HEAD :
- First, install the bypass on the water softener head.
Position the bypass at the rear of the head.
When the bypass is pushed fully home, insert both mounting
clamps in the slots provided.
Ensure that these mounting clamps are correctly installed before
filling the unit.
IMPORTANT: Install the water softener on the cold water system (5°C to 20°C).
IMPORTANT: Upstream of the water softener, install the following (in sequence):
- An unsoftened cold water pipe to supply the kitchen tap (not supplied).
- A shut-off valve (not supplied).
- A standard isolator (not supplied).
- The filter with a rating of 20 µm. Change the cartridge regularly,
in accordance with the manufacturer’s instructions (supplied).
- Downstream of the water softener, install a shut-off valve (not supplied).
Install these recommended accessories using standard unions.
CONNECTING THE WATER SOFTENER HEAD :
- First, install the bypass on the water softener head.
BYPASS OPERATION
Position the bypass at the rear of the head.
When the bypass is pushed fully home, insert both mounting
clamps in the slots provided.
Ensure that these mounting clamps are correctly installed before
filling the unit.
To Next Page
Loading...
Need help?
General