AlterG Via400 - Appendix D: Emc Statement

D-000348'Rev.'A'
52'
7
OOP
Over pressure during
use/calibration
Pressure exceeded set
point
8
nPc
Under pressure during
use
Pressure did not reach
set point
Table 1. General Error Codes
Write down any observed error codes prior to calling AlterG Customer Support
(510-270-5369).
Appendix D: EMC Statement
Warning:
• The VIA400 needs special precautions regarding EMC and needs to be installed and
put into service according to the EMC information provided in this manual.
• Portable and mobile RF communications equipment can affect the Via400
• The use of accessories, transducers and cables other than those specified by Alter-
G Incorporated, may result in increased EMISSIONS or decreased IMMUNITY of the
EQUIPMENT.
• This EQUIPMENT should not be used adjacent to or stacked with other equipment
and that if adjacent or stacked use is necessary, the EQUIPMENT should be
observed to verify normal operation in the configuration in which it will be used.
• List of all cables and maximum lengths. Include manufacturer, model number or
part number
• List of all accessories and transducer. Include manufacturer, model number or part
number.
'
Guidance and manufacturer’s declaration – electromagnetic emissions
The EQUIPMENT is intended for use in the electromagnetic environment specified below.
The customer or the user of the EQUIPMENT should assure that it is used in such an environment.
Emissions Test
Compliance
Electromagnetic environment – guidance
RF emissions
CISPR 11
Group 1
The EQUIPMENT uses RF energy only for its internal
function. Therefore, its RF emissions are very low and are not
likely to cause any interference in nearby electronic equipment.
RF emissions
CISPR 11
Class A
The EQUIPMENT is suitable for use in all establishments,
including domestic establishments and those directly
connected to the public low voltage power supply network that
supplies buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage Fluctuations/
Flicker emissions
IEC 61000-3-3
Complies
Table 2. Electromagnetic Emissions