What to do if my Alto-Shaam 500-1D is not operating properly?
If your Alto-Shaam Warming Drawer isn't working correctly, begin by checking the main power circuit breaker for the unit. Also, make sure the circuit breaker on the back of the unit is switched on, if your model has one.
What to do if my Alto-Shaam 500-1D is not working?
If your Alto-Shaam Warming Drawer isn't operating properly, first check the main power circuit breaker for the unit. Also, verify that the circuit breaker on the back of the unit is turned on, if there is one. Do not attempt to repair the unit beyond this point; contact Alto-Shaam for the nearest authorized service agent.
Why does my Alto-Shaam 500-1D show an air sensor error?
If your Alto-Shaam Warming Drawer indicates that the air sensor integrity is not within range (specifically, if the reading is more than ± 20 ohms), you will need to replace the sensor.
General| Model | 500-1D |
|---|---|
| Type | Warming Drawer |
| Electrical | Single Phase |
| Material | Stainless Steel |
| Temperature Range | Adjustable thermostat up to 200°F (93°C) |
| Voltage | 120 Volts |
To Next Page
