INSTALLATION
Dra wer Wa rmer ▪ Oper a tor’s M a n ual ▪ M N-46969 ▪ Rev 1 ▪ 5/ 2 0
22
Continued from previous page
Position the drawer
warmer
To position the drawer warmer, do the following.
Step Action
1. Make sure that:
▪ The location where the drawer warmer is being installed is rated to
support the weight of the drawer warmer;
▪ The drawer warmer is within five feet of the appropriate electrical
outlet;
▪ You follow the drawer warmer clearance guidelines.
2. Move the drawer warmer to the installation location and onto the final
resting surface.
The drawer warmer is now correctly positioned.
3. See topic How to Clean the Drawer Warmer and thoroughly clean the drawer
warmer.
Connect power 4. To connect electric power to the drawer warmer, do the following.
Plug the drawer warmer into a properly grounded receptacle only,
positioning the drawer warmer so that the plug is easily accessible in case
of an emergency. Arcing will occur when connecting or disconnecting the
drawer warmer unless all controls are in the "OFF" position
For hard-wired drawer warmers, set the disconnect switch to the ON
position.
Continued on next page
1" (25mm)
2" (51mm)
18" (457mm)
from heat
producing
equipment
3" (76mm)
1" (25mm)" (25mm)
CEE 7/7NEMA 5-15P CH-1216P
TH-TS-009664
BS-1363 AS/NZS-3112NEMA 6-15P
To Next Page
Loading...
