MN-29742 (Rev. 6) 02/16 • Drawer Warmers • 7
1.
2.
3.
This section is provided for the
assistance of qualified and trained
service technicians only and is not
intended for use by untrained or
unauthorized service personnel.
Failure to observe this precaution
may void the warranty.
To prevent Serious injury, death,
or property damage, ALWAYS
disconnect unit from power source
before cleaning or servicing.
To prevent SERIOUS INJURY,
DEATH, or PROPERTY DAMAGE:
All electrical connections must be
made by a qualified and trained
service technician in accordance
with applicable electrical codes.
This appliance MUST be adequately
grounded in accordance with local
electrical codes or, in the absence
of local codes, with the current
edition of the National Electrical
Code ANSI/NFPA No. 70. In Canada,
all electrical connections are to be
made in accordance with CSA C22.1,
Canadian Electrical Code Part 1 or
local codes.
Wire diagrams are located inside the bonnet of the unit.
For CE approved units:
shock hazard between the appliance and other
appliances or metal parts in close vicinity,
an equalization-bonding stud is provided. An
equalization bonding lead must be connected to
this stud and the other appliances/metal parts
to provide sufficient protection against potential
difference. The terminal is marked with
NOTICE:
voltage phase cycle/hz amps kW
NeMa 5-15p
15a, 125v plug
NeMa 6-15p
15a, 250v plug
plugs Rated 250v
ch2-16p bs 1363 as/Nzs 3112 cee 7/7
To Next Page
Loading...
