OPERATION
Ve ct or F ® Se ries ▪ O pera to r’s Man ual ▪ MN-468 94 ▪ Rev 1 ▪ 7/2 0
83
Continued from previous page
3. Plug the USB drive c into the port.
4. Scroll to System Backup & Update.
Touch the Update system software d setting.
Touch Control Board (CB) to update the control board. The oven loads the
selected software. The oven verifies the file and then updates the CB.
Touch Front End to update the user interface software. The oven loads the
selected software.
Touch Back End to update the supporting software between the control
board (CB) and interface board (IB). The oven loads the selected software.
Continued on next page
NOTICE
Do not remove the USB drive during the update
process.
To Next Page
