Alto MAC 2.2 Owner's Manual

12
6. TECHNICAL SPECIFICATIONS
ELECTRICAL SPECIFICATIONS
INPUT SENSITIVITY
INPUT IMPEDANCE
FREQUENCY RESPONSE
(at 10dB below rated output power)
VOLTAGE GAIN
DISTORTION(SMPTE-1M)
S/N ratio
Full short circuit, open circuit, thermal, ultrasonic, and RF protection
stable into reactive or mismatched loads, turn ON/OFF, muting, tried
crowbar
GENERAL SPECIFICATIONS
PROTECTIONS
1.15 V (+3.4 dBu)
10 K Unbalanced 20 K Balanced
25 Hz~25 KHz +0/-1 dB
-3 dB points: 5 Hz~50 KHz
1.15 V (+3.4 dBu)
30 dB
<0.03%
100 dB
32dB
<0.03%
100 dB
34 dB
<0.03%
100 dB
1.15 V (+3.4 dBu)
4 Ohms (RMS)
4 Ohms (EIAJ)
2 Ohms (EIAJ)
8 Ohms (RMS)
8 Ohms (RMS)
POWER SPECIFICATIONS
MAC 2.2
750 W 2 x
350 W x 2
230 W x 2
710 W
1500 W
1000 W
510 W
285 W
1000 W
2200 W
MAC 2.3
MAC 2.4
1800 W
900 W
560 W
1800 W
3100 W
Stereo Mode
(Both channels driven)
20Hz~20KHz
Bridge Mono Mode
20Hz~20kHz
CONTROLS
INDICATORS
CONNECTORS
POWER SUPPLY
DIMENSIONS
WEIGHT
Front: AC switch, Input level control for each channel
Rear: stereo/ parallel/ bridged selector, 30Hz filter selector clip
ON/OFF selector.
INPUT : Active balanced XLR and 1/4"(6.3 mm)TRS
OUTPUT: "Touch-proof" binding posts and speak-on jacks.
Available for 110-120 V or 220~240 V AC, 50/60 Hz
483(W) 460(D) 88.8(H)mm
13.6 kg 15.6 kg 20.55 kg
SIGNAL: 2 green LED
POWER: 1 Blue LED
CLIP: 2 red LED
PROTECTION: 1 red LED

Alto MAC 2.2 Specifications

General

Brand	Alto
Model	MAC 2.2
Category	Amplifier
Language	English