Alutech LG Series - Remote Control Deletion

ПРИВОДЫ LEVIGATO (СЕРИЯ LG) | ПРИВОДИ LEVIGATO (СЕРІЯ LG) | LEVIGATO DRIVES (LG SERIES) 71
ADJUSTMENT
DELETING THE REMOTE CONTROL
AND DEFINING OF THE RECORD NUMBER OF THE REMOTE
The table12 describes the settings, it is used when there is a remote control but the information
for the remote control number in the drive memory is not available.
1
Press and hold the button
for about 5secs to enter the
programmingmode
2
After the appearance of ‘P1’ inscription press the button
3
After the appearance of ‘P2’ inscription press the button
4
With the button or select the required setting:
‘F7’—dening the number of the remote control;
‘F8’—deleting the remote control
5
After the appearance of required setting (‘F7’ or ‘F8’) press the button
6
‘rc’ is shown on the display, which means that a signal from the remote control
is expected
7
Press the selected control button 3times
8
The display will automatically show the number of the remote control in the
drive memory. If the remote control is not recorded, ‘no’ will be shown on the
display
9
To set ‘F8’ press the button
. A dot will disappear from the display, this
means that the remote control with the selected number is deleted from the
memory
10
In three seconds the switch to the waiting mode for the signal from the next
remote control will take place. To exit the programming mode press the
button
or wait for 15seconds (until automatic exit the setup menu)
The table13 describes the settings of deleting the remote control when it is absent but the
information for the remote control number in the drive memory is available.
1
Similarly to tab.12 items 1 to 4, enter the menu ‘P2’ and select the setting ‘F9’
2
After the appearance of ‘F9’ inscription press the button
3
The number of the rst recorded remote control will appear on the display.
With the button
or select the of remote to delete
Table 12
Table 13