MH-1201A
6. Installation and Connection
6-7
(10) Mounting the Flexible Feeder (or
the Secondary Cable)
Connect the flexible feeder (or the
secondary cable) to the feeder terminal.
When a stiff feeder is connected, the
electrode does not move smoothly.
(11) Connecting the Solenoid to the
Regulator
Install the solenoid and the regulator near
the welding head.
Set the air supply pressure to 0.5 to 0.7
MPa.
Mounting Screw
Washer
Nut
Flexible Feeder
ATTENTION
Flexible feeder, secondary cable and
screws are sold separately.
Please provide them.
Figure 6-9
Figure 6-10
Solenoid
Regulator
Tube
[Recommendation]
Outer dia.: φ10
Inner dia.: φ6.5
Length: 300mm or less
To Next Page
