Amada vm1200 - Checking before Start of Dayswork; Hydraulic Oil Level; Cutting Fluid Level; Saw Blade

V
-3
CHECKING BEFORE START OF DAY’S
W
ORK
Before starting the machine every day, check it for the following items:
HYDRAULIC OIL LEVEL
Check the hydraulic oil
level with the sight gauge.
If it is low, add the same
hydraulic oil. For the
recommended hydraulic
oils and other details, refer
to page V-6.
CUTTING FLUID LEVEL
Check the cutting fluid level
with the sight gauge.
If it is low, add the cutting
fluid. If the cutting fluid is
deteriorated, change all of
it. For the other details,
refer to page V-6.
SAW BLADE
Check that the saw blade
is properly installed on the
drive and driven wheels
and that its teeth are not
chipped or worn.