24
Check the burner flames for:
1. Good adjustment
6WDEOHVRIWDQGEOXH
1RWFXUOLQJIORDWLQJRUOLIWLQJRII
%ඝකඖඍක)ඔඉඕඍ
WARNING
7ඉඞඑඌඍකඛඖඉඔඑඖඒඝකඡකඌඍඉගඐඌඝඍගඍඔඍඋගකඑඋඉඔඛඐඋඓ
ඌඖගකඍඕඞඍඉඖඡඑඖගඍකඖඉඔඋඕඉකගඕඍඖගඋඞඍකඛකඉගගඍඕග
ඉඖඡඉඌඒඝඛගඕඍඖග&ඖගඉඋගඉඝඉඔඑඎඑඍඌඛඍකඞඑඋඍකඉගඖඋඍඑඎඉඖ
ඉඊඖකඕඉඔඎඔඉඕඍඛඐඝඔඌඌඍඞඍඔ
At least once a year, prior to or during the heating season,
PDNHDYLVXDOFKHFNRIWKHEXUQHUÀDPHV
127(7ඐඑඛඟඑඔඔඑඖඞඔඞඍකඍඕඞඑඖඏඉඖඌකඍඑඖඛගඉඔඔඑඖඏ
ගඐඍඐඍඉගඍචඋඐඉඖඏඍකඌකඖගඐඍඝඖඑගඟඐඑඋඐඑඛඐඍඔඌ
ඊඡගඟඛඋකඍඟඛ,ඎඡඝඉකඍඝඖඋඍකගඉඑඖඉඊඝගඡඝක
ඉඊඑඔඑගඡගඌගඐඑඛඋඖගඉඋගඉඝඉඔඑඎඑඍඌඛඍකඞඑඋඍක
,IDVWURQJZLQGLVEORZLQJLWPD\DOWHUWKHDLUÀRZSDWWHUQ
within the unit enough that an inspection of the burner
ÀDPHVLVQRWSRVVLEOH
&ඔඍඉඖඑඖඏ%ඝකඖඍකඛ
1. 6KXWRႇHOHFWULFSRZHUDQGJDVVXSSO\WRWKHXQLW
2. Remove the screws securing the manifold to the burn-
er retention bracket. Remove the manifold and rotate
each burner counterclockwise to remove.
Burner
Bracket
Burner
Manifold
0ඉඖඑඎඔඌ$ඛඛඍඕඊඔඡ
3. Remove the burners.
4. Use a bottle brush to clean burner insert and inside of
the burners.
5. Replace burners and manifold, inspect the burner as-
sembly for proper seating of burners in retention slots.
6. Reconnect electrical power and gas supply.
CAUTION
/ඉඊඍඔඉඔඔඟඑකඍඛකඑකගඌඑඛඋඖඖඍඋගඑඖඟඐඍඖඛඍකඞඑඋඑඖඏ
උඖගකඔඛ:එකඑඖඏඍකකකඛඋඉඖඋඉඝඛඍඑඕකඍකඉඖඌඌඉඖඏඍකඝඛ
ඍකඉගඑඖ
CAUTION
$ඔඟඉඡඛඞඍකඑඎඡකඍකඍකඉගඑඖඉඎගඍකඛඍකඞඑඋඑඖඏ
For further information on the yearly inspection, consult the
8VHU0DQXDO,WLVUHFRPPHQGHGWKDWDTXDOL¿HGVHUYLFHU
inspect and service the unit at least once each year.
Turn the unit on at the thermostat. Wait a few minutes,
VLQFHDQ\GLVORGJHGGXVWZLOODOWHUWKHQRUPDOÀDPHDSSHDU-
ance. Flames should be predominantly blue and directed
into the tubes. They should not be yellow. They should ex-
tend directly outward from the burner ports without curling
GRZQZDUGÀRDWLQJRUOLIWLQJRႇWKHSRUWV
ACCESSORIES AND FUNCTIONAL PARTS
6ඐඍඍග0ඍගඉඔ$උඋඍඛඛකඑඍඛ
$GGLWLRQDODFFHVVRULHVFDQEHSXUFKDVHGWR¿WVSHFL¿F
application needs. Parts and instructions are available from
your distributor.
)ඝඖඋගඑඖඉඔ3ඉකගඛ
Auxiliary Limit Switch Flame Roll-out Switch
Blower Housing Flame Sensor
Circulator Blower Motor *DV2UL¿FH
Blower Wheel *DV9DOYH
Burner Heat Exchanger
Capacitor High Limit Switch
Compressor Igniter
Condenser Coil Ignition Control
Condenser Fan Blade Induced Draft Blower
Condenser Fan Motor Pressure Switch
Contactor Pressure Switch Hose
Gas Manifold Thermostatic Expansion
9DOYH
Evaporator Coil Transformer
)ඝඖඋගඑඖඉඔ3ඉකගඛ/එඛග
*ඍඖඍකඉඔ,ඖඎකඕඉගඑඖ
1. Refer to the description in Functional Parts List when
ordering any of the listed functional parts. Be sure to
provide the unit model and serial numbers with the
order.
2. Although only functional parts are shown, all sheet met-
al parts, doors, etc. may be ordered by description.
3. Parts are available from your distributor.
To Next Page
Loading...
Need help?
General
