Amana APG M Series User Manual

6
UNIT LOCATION
WARNING
7඗඘කඍඞඍඖග඘඗ඛඛඑඊඔඍඍ඙ඝඑ඘ඕඍඖගඌඉඕඉඏඍ඘ක඗඘ඍකගඡඌඉඕඉඏඍ
඘ඍකඛ඗ඖඉඔඑඖඒඝකඡ඗කඌඍඉගඐගඐඍඎ඗ඔඔ඗ඟඑඖඏඊඝඔඔඍගඛ඘඗එඖගඛඕඝඛග
ඊඍ඗ඊඛඍකඞඍඌඟඐඍඖඑඖඛගඉඔඔඑඖඏගඐඍඝඖඑග
$ඔඔ,ඖඛගඉඔඔඉගඑ඗ඖඛ
• )RUSURSHUÀDPHSDWWHUQZLWKLQWKHKHDWH[FKDQJHU
and proper condensate drainage, the unit must be
mounted level.
• 7KHÀXHRXWOHWKRRGPXVWEHDWOHDVWLQFKHVIURP
DQ\RSHQLQJWKURXJKZKLFKÀXHJDVHVFRXOGHQWHU
a building, and at least three feet above any forced
air inlet located within ten feet. The economizer/
manual fresh air intake/motorized fresh air intake
and combustion air inlet mounted on the unit are not
DႇHFWHGE\WKLVUHVWULFWLRQ
• To avoid possible corrosion of the heat exchanger,
do not locate the unit in an area where the outdoor
DLULHFRPEXVWLRQDLUIRUWKHXQLWZLOOEHIUHTXHQWO\
contaminated by compounds containing chlorine or
ÀXRULQH&RPPRQVRXUFHVRIVXFKFRPSRXQGVLQFOXGH
swimming pool chemicals and chlorine bleaches, paint
stripper, adhesives, paints, varnishes, sealers, waxes
ZKLFKDUHQRW\HWGULHGDQGVROYHQWVXVHGGXULQJ
FRQVWUXFWLRQDQGUHPRGHOLQJ9DULRXVFRPPHUFLDODQG
industrial processes may also be sources of chlorine/
ÀXRULQHFRPSRXQGV
• To avoid possible illness or death of the building
occupants, do NOT locate outside air intake device
HFRQRPL]HUPDQXDOIUHVKDLULQWDNHPRWRUL]HGIUHVK
DLULQWDNHWRRFORVHWRDQH[KDXVWRXWOHWJDVYHQW
WHUPLQDWLRQRUSOXPELQJYHQWRXWOHW)RUVSHFL¿F
distances required, consult local codes.
• Allow minimum clearances from the enclosure for
¿UHSURWHFWLRQSURSHURSHUDWLRQDQGVHUYLFHDFFHVV
These clearances must be permanently maintained.
• 7KHFRPEXVWLRQDLULQOHWDQGÀXHRXWOHWKRRGVRQWKH
unit must never be obstructed. If used, do not allow
the economizer/manual fresh air damper/ motorized
fresh air damper to become blocked by snow or
debris. In some climates or locations, it may be
necessary to elevate the unit to avoid these problems.
• Damper must be on open position when appliance
PDLQEXUQHUVLVRSHUDWLQJ
• When the unit is heating, the temperature of the return
air entering the unit must be between 50°F and 100°F.
• Units manufactured on or after May 1, 2017 are
not permitted to be used in Canada for heating of
buildings or structures under construction.
*ක඗ඝඖඌ/ඍඞඍඔ,ඖඛගඉඔඔඉගඑ඗ඖඛ2ඖඔඡ
• When the unit is installed on the ground adjacent
WRWKHEXLOGLQJDOHYHOFRQFUHWHRUHTXDOEDVHLV
recommended. Prepare a base that is 3” larger than
the package unit footprint and a minimum of 3” thick.
• 7KHEDVHVKRXOGDOVREHORFDWHGZKHUHQRUXQRႇRI
water from higher ground can collect in the unit.
• The top of the unit should be completely unobstructed.
If units are to be located under an overhang, there
should be a minimum of 48” clearance and provisions
PDGHWRGHÀHFWWKHZDUPGLVFKDUJHDLURXWIURPWKH
overhang.
• Close to the wall application assures free,
unobstructed air to the other two sides. In more
FRQ¿QHGDSSOLFDWLRQVSDFHVVXFKDVFRUQHUVSURYLGH
a minimum 12” clearance on all air inlet sides. Allow
36” minimum for service access to the compressor
compartment and controls.
• Unit should be located a minimum of 3” away from the
wall with the connections facing the wall.
2ඝගඛඑඌඍ6ඔඉඊ,ඖඛගඉඔඔඉගඑ඗ඖ
5඗඗ඎග඗඘,ඖඛගඉඔඔඉගඑ඗ඖඛ2ඖඔඡ
127(7඗ඍඖඛඝකඍ඘ක඗඘ඍකඋ඗ඖඌඍඖඛඉගඍඌකඉඑඖඉඏඍඝඖඑග
ඕඝඛගඊඍඑඖඛගඉඔඔඍඌඑඖඉඔඍඞඍඔ඘඗ඛඑගඑ඗ඖ
• To avoid possible property damage or personal injury,
WKHURRIPXVWKDYHVXႈFLHQWVWUXFWXUDOVWUHQJWKWR
FDUU\WKHZHLJKWRIWKHXQLWVDQGVQRZRUZDWHU
loads as required by local codes. Consult a structural
engineer to determine the weight capabilities of the
roof.
5඗඗ඎග඗඘,ඖඛගඉඔඔඉගඑ඗ඖ

Amana APG M Series Specifications

General

Brand	Amana
Model	APG M Series
Category	Air Conditioner
Language	English