14
7. Select CHARGE MODE.
8. Select ON. Press DONE to initiate CHARGE mode. (System
will then run for 1 hour and either return to cooling or
heating mode depending on the mode thermostat is set
at COOL or HEAT, or stop if the thermostat is set for FAN
only mode.)
If charging is not complete after 1 hour, repeat
7. and 8.
Refer to STEP 5 and STEP 6 for refrigerant charge
level adjustment.
9. To terminate CHARGE MODE, select CHARGE
mode screen again. Press OFF. Press DONE to
terminate CHARGE MODE.
10. Once CHARGE MODE is complete and has been
terminated, navigate to HOME screen. Enter
normal operation with temperature offset or thermostat
schedule, as desired.
To Next Page
Loading...
Need help?
General