9
RISQUE D'INTOXICATION AU MONOXYDE DE CARBONE
AVERTISSEMENT
intoxication au monoxyde de carbone ou la mort. Les
-
de sa mise en marche, alors que tous les autres appareils
marche :
ventilation.
conformes aux exigences du National Fuel Gas Code,
ANSI Z223.1/NFPA 54 ou du Code d’installation du gaz
4. Fermer le registre des foyers.
de ventilation. Mettre en marche tous les ventilateurs
de tirage, comme celui des hottes de cuisine et des
6. Suivre les instructions d’allumage. Mettre en marche
minutes de fonctionnement du br leur principal. Utiliser
au National Fuel Gas Code, ANSI Z223.1/NFPA 54 et
(ou) au National Fuel Gas Code, ANSI Z223.1/NFPA
54 et (ou) au Code d’installation du gaz naturel et du
propane, CSA B149.1
In an area having good air circulation, locate the thermostat
the following:
• Drafts, or dead spots behind doors, in corners, or
under cabinets.
• Hot or cold air from registers.
• Radiant heat from the sun.
• Concealed hot or cold water pipes, or chimneys.
• Unconditioned areas behind the thermostat, such as
an outside wall.
Consult the instructions packaged with the thermostat for
mounting instructions and further precautions.
T
O
AVOID
PROPERTY
DAMAGE
,
PERSONAL
INJURY
OR
DEATH
,
SUFFICIENT
FRESH
AIR
FOR
PROPER
COMBUSTION
AND
VENTILATION
OF
FLUE
GASES
MUST
BE
SUPPLIED
. M
OST
HOMES
REQUIRE
OUTSIDE
AIR
BE
SUPPLIED
INTO
THE
FURNACE
AREA
.
WARNING
Improved construction and additional insulation in buildings
around doors and windows. These changes have helped in
reducing heating/cooling costs but have created a problem
other fuel burning appliances. Appliances that pull air out
increase the problem by starving appliances for air.
House depressurization can cause back drafting or improper
-
ing occupants to gas combustion products that could include
carbon monoxide.
If this furnace is to be installed in the same space with other
gas appliances, such as a water heater, ensure there is an
adequate supply of combustion and ventilation air for all ap-
pliances. Refer to the latest edition of the National Fuel Gas
Code NFPA 54/ANSI Z223.1 or CAN/CSA B149 Installation
Codes or applicable provisions of the local building codes
for determining the combustion air requirements for the ap-
pliances.
This furnace must use indoor air for combustion. It cannot be
installed as a direct vent (i.e., sealed com bustion) furnace.
Most homes will require outside air be supplied to the furnace
area by means of ventilation grilles or ducts connecting directly
to the outdoors or spaces open to the outdoors such as attics
or crawl spaces.
To Next Page
