amaran 60x - Installations; Protection Cover Installation; Bowens Mount Reflector Installation; Light Setup and Mounting

-6-
Installations
1. Attaching/detaching the protection cover
2. Installation and removal of Bowens Mount Mini Reflector
Push the lever handle according to the arrow direction shown in the picture, and rotate the
Bowens Mount Mini Reflector into it.Rotating in the opposite direction pulls out the Bowens Mount
Mini Reflector.
* Notice: Always remove the protection cover prior to turning on the light. Always re-install the
cover when packing it away.
3. Setting up the Light
Adjust the lamp body to the appropriate height, rotate tie-down to fix the lamp body on the tripod,
then adjust the lamp body to the required angel, and tighten the lock handle.
Push the handle of the lever in the direction of the arrow shown in the picture, and rotate the cover
to pull it out.Reverse rotation will put the protective cover into.
1
2
3
1
2
3