Other important keywords
Go to Command
With regard to the contents of the previous page (memory of the last command), we found that for the
convenience of users, Alexa always kept the last place and the last used tool in memory this means Alexa
stays in the where the command was executed without mentioning the place name.
In addition, here is the list to tell Alexa to go to a specific place or go to a specific device.
The keywords of this is
Go to
or
Go for:
Go to {place} {pos} {device}
Go for {place} {pos} {device}
Example
Go to the kitchen.
Go to the first floor.
Go to the saloon fan.
Go for the kitchen's first lamp.
However, by executing this command, there is no special event (that is if something is turned off or not
turned on), but just Alexa goes to that location and waits for your command, and in fact, with this command,
you can change the "memory of the last command". For example, suppose you want to issue a few
instructions about the bulbs, curtains and fan, now instead of saying:
Turn on the parking lamp.
Turn on the parking fan.
Close the parking shutter.
Just ask Alex to go to the parking area so that the next commands are all in the parking area.
Go to parking.
Turn on lamp.
Turn on fan.
Close shutter.
Until another command has changed the parking location, like all other commands, the last place and the
tool in the "Last Command Memory", is kept, also if you want to know how to find out about the last
stored location in memory, or ask " Clear the last command " memory, refer to the two subsequent
instructions
(On the next page).
To Next Page
Loading...
