AC Fan Speed Command
This command is used for Devices such as AC fan, FCU, split AC, HVAC etc., and is used to adjust
the fan speed.
The keyword is the Speed command and must be {speed Mode} with its form as follows:
Speed of {place.pos.device} to {speedMode}
Speed {speedMode} for {place.pos.device}
{place.pos.device} set speed to {speedMode}
Example:
Change speed of fan to high
Set the ac speed fast
Speed ventilator, slow
Ventilator speed, low
The parking's fan speed medium
Set speed of saloon air condition to auto
Meanwhile, the {speedMode} parameter includes: high / high / fast / faster / raise / up and medium / mid /
middle and auto and slow / low / reduce / down (respectively) for speed: high, medium, automatic and
slow used
Changing Temperature Command
This command is applicable to the Air Conditioning compatible cooling and heating systems and is used to
set the temperature
The keyword is the temperature command and should be {degree} and {mode}, its form is as follows:
{mode} temperature of {place.pos.device} to {degree}
{place.pos.device} {mode} temperature to {degree}
{place.pos.device} temperature of {mode} to {degree}
Example: (Alternatively, Mood, cooling, heating, auto options)
Set cooling temperature of ac to 18
Heating temperature of air condition to 25
Saloon air condition heating temperature to 20
Set Spilt auto temperature to 20
Spilt temperature of cooling to 16
Spilt temperature to 20 [if mode is null --> mode = auto]
Temperature of ac to 18 [mode = auto]
Therefore, if the command, the mode of cooling and heating is not mentioned,
Auto
is considered, as
well some device does not support Mood such as floor-heating, so there is no need to mention mode:
Floor heating temperature to 22
Set temperature of Floor heating to 22
Set heater temperature to 28
To Next Page
Loading...
Need help?
General
