What should I do if the machine computer has failed on my Amazone Farm Equipment?
If the machine computer has failed, it indicates that communication with the second machine computer is not possible. Check the computer connections, plugs, and computer function. Also, verify that the correct machine type is selected.
Why is the fertiliser metering speed too high on my Amazone Farm Equipment?
If the fertiliser metering speed is too high, it could be because the metering unit speed is not allowed. To resolve this, try driving slower, check if the speed calculation is wrong, or ensure the target fertiliser quantity is not set too high.
Why is the setpoint deviating significantly from the calibration value on my Amazone Farm Equipment?
If the setpoint deviates significantly from the calibration value, it's because there's a deviation greater than 50 percent between the target fertiliser quantity in the calibration menu and in the job menu. Determine the new calibration factor for fertiliser or ignore by pressing the input key (caution: wrong spread rate is possible!).
What causes double layers in row 'x' with Amazone Farm Equipment and how to resolve it?
Double layers in a row can occur if the optosensor detects too many grains. To resolve this, check the hose seat at the threaded unions, check the fluid bed, and adjust the scraper bar setting.
What causes gaps in row 'x' with Amazone Farm Equipment and how to fix it?
Gaps in a row can occur if the optosensor detects too few grains. To fix this, clean the optosensor, remove any clogging grain, check the seat of the injection hose, check the fluid bed, and adjust the scraper bar setting.
Why is the seed singling not responding on my Amazone Farm Equipment?
If the seed singling isn't responding, it means that despite speed detection, the revolution of the singling drum is not detected. Check the connection to the geared motor and test manual activation of the motor in the diagnostics menu.
Why is the fertiliser metering unit not turning on my Amazone Farm Equipment?
If the fertiliser metering unit isn't turning, even with speed detection, the revolution of the singling drum might not be detected. You should check the motor and sensor connections, verify the sensor's position, remove any drive blockages, and check the rate setting on the vario gearbox. Also, review the settings in AMATRON, specifically the alarm delay time of the metering shaft, the fertiliser monitoring unit (number of shafts), and the fertiliser hopper (off/on).
What should I do if my Amazone Farm Equipment shows 'Pulses per 100 m missing'?
If you see a 'Pulses per 100 m missing' error, it means the pulse per 100 m is set to zero. You need to enter or determine the correct pulses per 100 m value.
What to do if seed fill level is insufficient on Amazone Farm Equipment?
If the seed fill level is insufficient, it could be because the filling level sensor does not detect seed. Try topping up the seed, ensure the sensor position is correct, and distribute the seed uniformly. You can also call up the diagnostics menu to check if the sensor is defective.
What to do if the speed is too high on Amazone Farm Equipment?
If the speed is too high, it's likely due to excessive operational speed. Try driving slower, and also verify that the speed calculation is correct.
General| Transport Width | 3 m |
|---|---|
| Working Width | 9 m |
| Row spacing | 187.5 mm |
| Tractor Power Required | 120-150 hp |
| Required Tractor Power | From 110 kW / 150 HP |
Details operator and user obligations for safe handling and fault-free operation.
Guidelines for carrying out prescribed maintenance and repair work safely.
Ensures the tractor meets requirements for safe operation with the implement.
Procedures to secure the tractor and implement before any work.
Instructions for coupling and uncoupling the pneumatic brake system.
Step-by-step guide for safely coupling the implement to the tractor.
To Next Page
