2.2.22 Special care should be taken when the implement is coupled to or off the
tractor.
2.2.23 Secure implement and tractor against unintentional rolling away.
2.2.24 Take implement only into Operation only when all guards are fixed in position.
When using “Opti-set” spreading discs OS 30-36 make sure the guard tube is bolted
to the broadcaster.
2.2.25 Fitting the machine to the three-Point linkage of the tractor bring all control
levers in such a Position at which an unintentional lifting or lowering is impossible!
2.2.26 When actuating the control levers for the three-Point linkage never step
between tractor and implement!
2.2.27 When driving on public roads with a lifted machine the lifting control lever
should be locked against unintentional lowering - before leaving the tractor lower the
mounted implement onto the ground and remove ignition key!
2.2.28 Nobody should stay between tractor and implement if the tractor is not
secured against rolling away by the parking brake and/or by chocks!
2.2.29 When fitting to the three-Point linkage the mounting categories at the tractor
and the implement must coincide!
2.2.30 Working implements should only be transported and driven on tractors which
are designed to do this!
2.2.31 Check maximum permissible axle loads of the tractor (see vehicle docu-
ments).
2.2.32 DO not exceed maximum permissible transport measurements of the traffit
department.
2.2.33 Fit and check transport gear, e.g. traffit lights, warning- and protection
devices!
2.2.34 On all hydraulically actuated pivoting Parts exists danger of injury by bruising
and trapping.
2.2.35 The release ropes for quick coupler should hand freely and in the low Position
must not release the quick coupling by themselves.
2.2.36 Affix any ballast weights always as prescribed to the correct fixing Points!
To Next Page
Loading...
