2.2.54 Prevent P.T.O. guard from spinning by fixing the provided chain to a nearby
static part (see Fig. 1 b).
Maintenance
2.255 Liquids leaking under high pressure (Diesel fuel, hydraulic Oil) tan penetrate
the skin and Cause severe injury. When injured see a doctor immediately. Danger of
infection!
2.2.56 Dispose of old oiis, grease and filters as prescribed by law.
2.2.57 Check and retighten if necessary nuts and bolts regularly, initially after 3 - 4
hopper fillings.
2.2.58 When conducting maintenance work on the lifted implement always place
suitable supports underneath.
2.2.59 When conducting electrical welding operations on the tractor or on the moun-
ted implement remove cable from the generator and the battery.
2.2.60 The hydraulic System is under high pressure.
2.2.61 When searching for leaks appropriate aids should be used because of the
danger of injury.
2.2.62 Before starting to do repair work at the hydraulic System relieve it of pressure
by actuating the control lever accordingly and stop tractor engine.
2.2.63 When fitting the hydraulic hoses to the tractor hydraulic sockets always ensure
that the hydrcjulic System on
the tractor as weil as on the implement side is without
pressure.
2.2.64 Fit the hydraulic hoses to the tractor according to the advice in the instruc-
tions.
To avoid wrong connection sockets and plugs should be colour coded. This
helps to prevent misoperation and reduces the danger of accidents caused by it.
2.2.65 The period of use of any hose circuit should not exceed six years including a
possible storing period of two years in maximum. Also when stored and used properly
hoses and hose circuits do age. Therefore their longevity and period of use is limited.
Deviations from the above may be accepted by the Health- and Safety Authorities
and depending on experience made and the danger potential. For hoses and hose
circuits made of thermoplasts other guide lines
may
prevail.
To Next Page
Loading...
