19
4. Technical data
4.1 Technical data of ABT-CU-8LCD
Model ABT-CU-8LCD
Power supply
48 V DC (operating range 40-57 V DC)
connector with screw terminals M2.5,
the distance between the partitions of 5.08mm
Power consumption Up to 60 W (depends on conguration)
Number of function slots 4
Number of control slots 8
Messages
Supported SD HC up to 32 GB / The set included 512 MB
SLCSDHC cards provide more than 20 min ofthemessages
LCD display 4,5” LCD touch screen
DSP
Implemented 3 band parametric EQ on all inputs on
control units / 16 band parametric EQ and Delay lines
on each of the audio output
Data communication
Communication between devices over large distances:
Ű 1000BASE-X on the ber
Ű 2 ports provide a redundant connection
Communication between devices installed side by side:
Ű 1000BASE-TX / RJ45 CAT5E cables after –
2 ports available on the back panel.
Ű 100BASE-TX / RJ45 CAT5 cables after –
1 port available on the rear panel
for connection to an external network (see notes)
Ű 100BASE-TX / RJ45 CAT5 cables after – 1 port available
on the front panel (the main processor card) for
connection to an external network
Fiber module –
connector type / kind of ber
Modules type SFC / Connector SC / LC /
Multimode or single-mode / E 30 or E 90, OM lub OM2
Communication with PC
PC software: RJ45 connector twisted pair connection
TIA/EIA 568-B by the Ethernet protocol
Operating temperature 0°C / +60°C
Operating humidity 15% to 80% (non-condensing)
To Next Page
Loading...
Need help?
General