6.2 GEN menu
In this menu the timecode generator parameters can be set. The generator starts from 00:00:00:00 and
can be set from the following sources:
Press 1, Preset: Set generator from different sources
Select 1, RTC: sets generator to internal real time clock
Set: time, user (date and or user bits), both
Select 2, RESET: sets selected bits to zero and generator start counting
Set: time, user, both.
Select 3, AUX: sets timecode from standby timecode generator
Set: time, user, both
Select 4, GPS: sets generator to GPS time
Set: time, user, both
Press 8, Edit: Manually edit the time, user bits and frame rate
Select 1: Time / Select 2: User bits / Select 3: Frames
Press 0, Lock: Locks out keypad. Release with shift + lock.
To Next Page
