Ambient Lockit+ - Page 15

15Lockit+ Users manual |
9.2 ACN Settings
Monitor and manage all Lockits within the selected ACN channel.
• “Your Lockit+”
• Start C-Jam master
• Select ACN channel
• Rename unit
• ACN Radar
• Check status of connected devices (online/oine)
• Grid view and list view of ACN devices
- Online / oine
- Rename units
- Battery status
- Timecode aberration
• Project tune devices
Note: If you want to re-calibrate your Lockit Setup after some years of operation,
you can perform a Project Tune (former feature of the discontinued ACC controller).
All Lockits within the selected ACN Channel will be tuned simultaneously.
The process will take approx. 2 minutes during which the devices will rapidly blink
red and green.
Tune value will be overwritten by the factory value on a factory reset.
Attention: NEVER initiate a Project Tune during a shoot. There will be a hard reset
of the sync pulse when the process is nished. This will potentially bring cameras
in operation out of clock and compromise active recordings.