AMBROGIO A020EL0 - Set Up; Operation of the Robot in Manual Mode with “AUTO LED OFF”; Operation of the Robot in Automatic Mode with “AUTO LED ON”

21
User’s manual
EN
SET UP
The set up procedure is performed when the robot is started for the rst time and after a long period of inactivity.
• Check that the height of the lawn surface to be cut is compatible with the proper functioning of the robot (see “Technical
Specications”).
• Adjust the cutting height as desired (see “Adjustment of Cutting Height).
• Make sure the work area has been correctly marked and that there are no impediments to the regular functioning of the robot
as described in the section “Preparation and Marking of Boundaries of the Work Areas” and following sections.
• Make sure there are no large puddles in the garden due to heavy rain.
• Place the robot inside the charging station.
• Press the ON/OFF key and wait a few seconds for the robot to turn on completely.
• The battery LED turns orange and remains xed for a few seconds as it recognises the charging station.
• The robot is ready for use. Press the “AUTO” key to set automatic or manual operation.
Operation of the robot in manual mode with “AUTO LED off”
• When the battery is fully charged, press the START/PAUSE key to start the work cycle. When the battery capacity is
exhausted, the robot returns to the charging station.
• If the garden has not been completely mowed, wait until the battery is fully charged and then start a new work cycle.
• For a better result, it is recommended to use the robot at least on every other day.
• To change the default settings of some robot functions, simply download the free application for smartphones; refer to section
“ACCESS TO MENU VIA APP”
Operation of the robot in automatic mode with “AUTO LED on”
• Thanks to the automatic mode the robot is programmed to work every day of the week. Through the mobile application you
can check the default time set.
• The number of work cycles is managed automatically by the robot based on the battery capacity. In automatic mode, the
robot exits the charging station to perform the work cycle and returns to recharge itself, and if necessary, to resume working
again.
• To change the default settings of the working time and other functions, simply download the free application for smartphones,
refer to paragraph “ACCESS TO MENU VIA THE APP”.