14
23
24
22
7. Audiotherm with
Visiotherm S
(Secuquick)
§ Please also ensuretofollow the user
manual of “AMC Secuquick softline”.
§ Only when the Audiotherm works along
with the Navigenio in the automatic
program (according to chapter 8), the
necessaryswitching functions are
automatically executed.
When the cooking time is over
(if acooking time has been set):
§ Single, repetitive beep is heard.
§ The display “0:00” flashes.
24
➔
Switch o stove.
➔
Stop beep, remove Audiotherm and switch o.
§ When the beep is heardand the symbol
“increase” flashes, the temperatureistoo low
(indicator under vegetable window).
23
➔
Set stove at higher level, stop beep.
In high-output stoves (for e.g. gas or induction
stoves), the signal can sound just beforethe stop
window is reached so that enough time remains
to go to the stove.
➔
Set stove at lower level, stop beep.
➔
During the cooking, pay attention to further
beeps of the Audiotherm and regulatelevel
setting if necessary.
§ When the beep is heardand the symbol
“reduce” flashes, the temperatureistoo high
(indicator in stop window).
22
➔
Set stove at low level (or switch o completely),
stop beep.
In gas and induction stoves, after reducing the
energy, the temperaturedisplay can fall under
80 °C for ashorttime and then rise again. In this
case, no beep is heardand you don’t have to set
the stove at higher level.
AMC_ADTH_EN.indd 14 21.04.15 11:34