AMD Radeon R7 260X User Manual

4. Remove any unneeded graphics cards from the computer.
Warning:
Some graphics cards can get hot while operating. Wait approximately five
minutes after turning off the computer before touching the card.
5. Locate the PCIe slots on the motherboard. If necessary, also remove the
corresponding back panel cover.
6. Align the new graphics card in the secondary PCIe slot next to the existing
graphics card and press firmly until the card is fully seated.
Tip: For optimal performance in a dual-GPU AMD CrossFire configuration,
make sure that each AMD Radeon™ R7 260X graphics card is separated by at
least one empty expansion slot.
7. If needed, connect the power supply to the cards.
Tip: The location of power connections may vary between models. They can
be located on either the side or back of the card.
12 AMD CrossFire™ Technology
AMD Radeon™ R7 260X Graphics © 2014 Advanced Micro Devices, Inc.

AMD Radeon R7 260X Specifications

General

GPU Architecture	GCN 1.1
GPU	Bonaire
Stream Processors	896
Core Clock	1100 MHz
Memory Size	2 GB
Memory Type	GDDR5
Memory Bus	128-bit
Memory Clock	1625 MHz
Memory Bandwidth	104 GB/s
Compute Units	14
Texture Units	56
ROPs	16
TDP	115 W
Shader Model	5.0
Process Size	28 nm
Transistors	2.08 billion
Die Size	160 mm²
Power Connectors	1x 6-pin
Outputs	HDMI, DisplayPort
OpenCL	OpenCL 1.2
OpenGL Support	OpenGL 4.3