Ameda Finesse - SET-UP INSTRUCTIONS; Before First Use: Cleaning The Hygienikit; Cleaning Warnings and Methods

10
4. SET-UP INSTRUCTIONS
4.1 Before First Use: Cleaning The Hygienikit
Before first use, unless otherwise directed by your healthcare
provider, prepare the product for use as follows:
1. POP OFF the adapter cap(s) from the flange(s).
2. SET ASIDE adapter cap(s), tubing and tubing
adapter— you do not need to take these apart from
each other. These 3 parts
DO NOT need to be
washed before first use or after each use— milk does
not come into direct contact with these parts.
Take apart the remaining parts, the diaphragm(s), flange(s),
valve(s) and milk storage bottles, including locking ring(s) and locking disc(s), since
these are the parts that can touch the breast milk once you begin pumping.
ALWAYS wash hands well with soap and water.
CLEANING: Cleaning by boiling
IMPORTANT:
Set aside tubing, adapter cap and tubing
adapter. These parts DO NOT need to be washed.
DO NOT allow boiling parts to contact bottom of pot. It may
cause damage to parts.
WARNING:
DO NOT leave boiling parts unattended.
Remove parts carefully from boiling water to avoid
burning. Boiled water and steam from boiled water can cause
severe skin burns, so use caution when boiling parts in water
and removing parts from boiling water.
!
1.
3.
4.
2.
• BOIL a pot of
clean water.
• PUT flange(s),
diaphragm(s), valve(s) and
bottle(s), locking ring(s)
and locking disc(s) into pot
for
20 MINUTES.
WASH your
hands.
REMOVE the
parts carefully
with clean tongs.
Air DRY on a
clean surface.
!
DO NOT wash
adapter cap, tubing
and tubing adapter.
Parts shown above.