Ameda Finesse - Pumping Operation; To Begin Pumping; Adjusting Suction and Speed

15
6.3 To Begin Pumping
1.
INSERT TUBING
adapter into pump
base, then turn
slightly to the right
while pushing in
firmly.
7.
TURN SUCTION
dial to left to turn
off.
8.
After pump is
off, if necessary,
INSERT a finger
between breast(s)
and breast flange(s)
to break suction.
2.
CENTER flange
on breast to create
seal.
3.
TURN SUCTION
dial to right to turn on.
Turn up to your highest
comfortable suction
level. If discomfort, turn
suction down.
4. 5.
TURN SPEED
dial all the way to
the right to highest
speed to start milk
flow.
Once milk flows,
TURN SPEED
dial to left to slow
pump speed to
help drain milk. Try
half way, adjust as
needed.
Once milk flow
slows, try for another
let-down.
TURN
SPEED all the way
up, then slow speed
when milk is flowing.
Repeat as needed.
6.
For SINGLE
PUMPING:
Remove one
tube from the
tubing adapter
and close one
side.
For
DOUBLE
PUMPING: Both
tubes should be
attached to the
tubing adapter.
a. b.