4
1
INSTALL ELECTRICAL BOX; Fig. 3
1. Frame out a 389mm x 265mm (15-5/4" X 10-3/8") rough
opening in wall for the WALL BOX (1) at the dimension
shown.
2. Fasten one end of the SAFETY CHAIN (2) and CLIP
(4) to the WALL BOX (1) with NUT & SCREW (3) provided.
3. Install the WALL BOX (1) into rough opening in the wall
Level and secure the WALL BOX (1) to the wall opening
with screws.
Important: Front face of WALL BOX (1) should be ush
with nished wall.
4. Cut a 2” hole for outlet pipe to xture at dimension shown.*
2
INSTALL SWEAT ADAPTER; Fig. 4
Note: Stop Valve inlet is 3/4" NPT. For optional sweat
connection, install Sweat Adapter (1) (Supplied) for 3/4"
copper pipe supply line.
1. Clean the end of the supply pipe. Push the threaded
SWEAT ADAPTER (1) until it is seated against the
internal stop. Sweat the ADAPTER (1) to the pipe.
2. Install the STOP VALVE (2) to the water supply line
with the outlet positioned as required (Behind the Wall).
3. Support piping as required.
3
FLUSH OUT SUPPLY LINES; Fig. 5
1. Open STOP VALVE (1).
2. Tu r n on water supply to ush line of any debris or
sediment.
3. Close STOP VALVE (1) and turn off water supply line.
CAUTION
Turn water supplies off before
beginning
M965643 Rev. 1.6 (11/16)
1
ROUGH OPENING IN WALL
265mm
(10-3/8")
389mm
(15-5/16")
LEVEL
3
2
4
Fig. 3 (TOP SPUD FIXTURE ILLUSTRATED)
*FOR HOLE LOCATION OF
SUPPLY ON BACK INLET
FIXTURES, REFER TO FIXTURE
BEING INSTALLED FOR CORRECT
HEIGHT FROM FINISHED FLOOR
120mm MAX.
(4-3/4) MAX.
176mm MAX.
(6-15/16) MAX.
Fig. 4
2
1
FILE
EDGES
CLEAN & SOLDER
TO ADAPTER (1)
115mm-134mm
(4-1/2 TO 5-1/4)
STOP VALVE
(3/4"NPT)
STOP VALVE OUTLET
Fig. 5
1
CLOCKWISE CLOSES
STOP VALVE
COUNTER-CLOCKWISE
OPENS STOP VALVE
FLUSH VALVE INSTALLATION
To Next Page
Loading...
