122770 06 18-09-2007 9
2.0 Repairs
Warning
The calibrator must be switched off before any attempt is
made to service the instrument.
Note…
If the software detects an error during operation, the error
will be shown in the display.
Make a note of the error message and contact your
distributor or AMETEK Denmark’s Service Department.
AMETEK Denmark’s liability ceases if:
• parts are re
placed/repaired using sp
are parts, which are
not identica
l to those recommended by the manufacturer.
• non-original
parts are used in any way when repa
iring
the instrument.
AMETEK Denmark’s lia
bility is restricted to errors that
originated from the factory.
2.1 Service Menu
In the Service Menu it is possible to check a number of conditions in
the equipment. To reach the Service Menu, follow the procedure
described on the following pages:
To Next Page
Loading...
