16 123199 04
C
A
L
I
B
R
A
T
I
O
N
I
N
S
T
R
U
M
E
N
T
S
4.0 Setting the main voltage and replacing
the fuses
Warning
The fuse box must not be removed from the power
control switch until the mains cable has been
disconnected.
The two main fuses must have the specified current and
voltage rating and be of the specified type. The use of
makeshift fuses and the short-circuiting of fuse holders
are prohibited and may cause a hazard.
Locate the main fuses in the fuse box in the power control
switch and check the voltage of the power control switch
(on/off switch (230V/115V)). If the voltage of the power
control switch differs from the line voltage, you must adjust
the voltage of the power control switch.
Open the lid of the fuse box using a screwdriver.
To Next Page
Loading...
Need help?
General
