Ametek Powervar Sinergy III 2kVA - 3.5 UPS Setting

A01-00159 Rev B
19
FU Bypass frequency unstable
BR Battery Replace
EE EEPROM error
3.5 UPS Setting
Parameter 1 Parameter 2
There are three parameters to set up the
UPS.
Parameter 1: It is for program alternatives.
Refer to below table.
Parameter 2 is the setting options or values
for each program.
01: Output voltage setting
Interface
Setting
Parameter 2: Output voltage
For 100/110/115/120/127 VAC models, you
may choose the following output voltage:
100: presents output voltage is 100Vac
110: presents output voltage is 110Vac
115: presents output voltage is 115Vac
120: presents output voltage is 120Vac
(Default)
127: presents output voltage is 127Vac
02: Frequency Converter enable/disable
Interface
Setting
Parameter 2: Enable or disable converter
mode. You may choose the following two
options:
CF ENA: converter mode enabled
CF DIS: converter mode disabled (Default)