Ametek Sorensen XG 100-15 User Manual

PROGRAMMABLE POWER
M370430-01 Rev F www.programmablepower.com
XG Family Programmable DC
Power Supply
Operating Manual
(firmware v 2.0 and higher)
670 Watts – 1700 Watts
Half Rack
Full Rack
6 V to 600 V Models:
6-110
6-220
6-220
8-100
8-187.5
8-200
12-70
12.5-120
12-140
20-42
20-76
20-84
33-25
30-50
33-50
40-21
40-38
40-42
60-14
60-25
60-28
80-10.5
80-19
80-21
100-8.5
100-15
100-17
150-5.6
150-10
150-11.2
300-2.8
300-5
300-5.6
600-1.4
600-2.6
600-2.8

Ametek Sorensen XG 100-15 Specifications

General

Output Current	0 - 15 A
Power Rating	1500 W
Type	Programmable DC Power Supply
Frequency	47-63 Hz
Storage Temperature	-20 to 70 °C
Protections	Overvoltage, Overcurrent, Overtemperature
Remote Sensing	Yes
Output Voltage	0-100V
Operating Temperature	0 to 50 °C
Communication Interface	GPIB, RS-232, USB

Summary

XG Family Programmable DC Power Supply

Features and Options

Installation

Basic Setup Procedure

Outlines the step-by-step process for installing the power supply.

Step 4: Selecting Load Wires

Step 5: Performing Functional Tests

Procedures for verifying the power supply's functionality after setup.

Step 6: Connecting Loads

Local Operation

Configuring Settings from the Front Panel

Guide to configuring power supply settings using the front panel controls.

Operating Modes

Explains the different operating modes: CV, CC, and CP.

Alarms and Errors

Using Over Voltage Protection (OVP)

Explains the function and setup of Over Voltage Protection.

Analog Programming (APG) and Isolated Analog Programming (ISOL)

Analog Programming (APG) of Output Voltage and Output Current

How to control output voltage/current using analog input sources.

Voltage-Controlled Voltage APG Setup

Remote Operation

Hardware and Connection Setup

Status Reporting in SCPI

Reset Command

Auto Sequence Programming

Communications Options

SETTING UP LAN/ETHERNET

Setup and configuration for LAN/Ethernet interface with MEB option.

LOCAL AREA NETWORK (LAN) OPTION

Setting a Static IP Address through Ethernet, USB, Serial Interfaces

Calibration and Troubleshooting

Main Voltage and Current Calibration Principle

Calibrating the Output Voltage

Procedures for calibrating output voltage gain and offset.

Calibrating the Output Current

Procedures for calibrating output current gain and offset.

Emergency Shutdown

Steps to take for immediate safety shutdown of the power supply.

APPENDIX A SCPI Command Reference

SCPI Conformance Information

Using SCPI Commands

How to format and use SCPI commands, including syntax rules.

SCPI Command Summary

APPENDIX C Specifications

Electrical Specifications for XG Family, 850 W

Detailed electrical specifications for the XG 850W models.

Electrical Specifications for XG Family, 1500 W

Detailed electrical specifications for the XG 1500W models.

Electrical Specifications for XG Family, 1700 W

Detailed electrical specifications for the XG 1700W models.