Ametek Sorensen XG 30-50 User Manual

PROGRAMMABLE POWER
M370430-01 Rev F www.programmablepower.com
XG Family Programmable DC
Power Supply
Operating Manual
(firmware v 2.0 and higher)
670 Watts – 1700 Watts
Half Rack
Full Rack
6 V to 600 V Models:
6-110
6-220
6-220
8-100
8-187.5
8-200
12-70
12.5-120
12-140
20-42
20-76
20-84
33-25
30-50
33-50
40-21
40-38
40-42
60-14
60-25
60-28
80-10.5
80-19
80-21
100-8.5
100-15
100-17
150-5.6
150-10
150-11.2
300-2.8
300-5
300-5.6
600-1.4
600-2.6
600-2.8

Ametek Sorensen XG 30-50 Specifications

General

Brand	Ametek
Model	Sorensen XG 30-50
Category	Power Supply
Language	English

Summary

2 Installation

Basic Setup Procedure

Outlines the step-by-step process for the initial setup and installation of the power supply.

Step 3: Connecting AC Input Power

Details the procedures and safety precautions for connecting the AC input power to the unit.

Step 4: Selecting Load Wires

Offers recommendations for selecting appropriate load wire sizes based on current carrying capacity.

3 Local Operation

Alarms and Errors

Details the various alarm conditions, their precedence, and how to manage them.

5 Remote Operation

Hardware and Connection Setup

Provides information on setting up hardware connections for various remote interfaces like RS-232, RS-485, USB, GPIB.

Configuring Remote Control Using RS-232

Guides users on setting up remote control via the RS-232 serial interface.

Configuring Remote Control using the USB Connector

Explains how to set up a USB connection for remote control and install necessary drivers.

6 Communications Options

SETTING UP LAN/ETHERNET

Provides procedures for network administrators to configure and connect the power supply via LAN/Ethernet.

Communication Configuration

Outlines three connection choices for remote control: LAN, direct-to-PC, and private network.

Setting a Static IP Address through Ethernet, USB, Serial Interfaces

Explains how to set static IP addresses for Ethernet, USB, and Serial interfaces.

7 Calibration and Troubleshooting

Main Voltage and Current Calibration Principle

Explains the concepts of gain and offset error in analog programming and their calibration.

Calibrating the Output Voltage

Provides detailed steps for performing gain and offset calibration for the output voltage.

Calibrating the Input Voltage APG Signal

APPENDIX B Error Messages

Command Error List

Execution Error List

Device-Specific Error List

APPENDIX C Specifications

Electrical Specifications for XG Family, 850 W

Provides detailed electrical specifications for the XG 850 Watt models across various voltage ranges.

AC Line Input Specifications for XG 850 Watt

Electrical Specifications for XG Family, 1500 W

Provides detailed electrical specifications for the XG 1500 Watt models across various voltage ranges.

AC Line Input Specifications for XG 1500 Watt

Electrical Specifications for XG Family, 1700 W

Provides detailed electrical specifications for the XG 1700 Watt models across various voltage ranges.

AC Line Input Specifications for XG 1700 Watt

APPENDIX D Rack Mount Options and Installation Instructions

Location Requirements