To Next PageTo Next Page
Need help?Do you have a question about the Ametek Sorensen XG 33-25 and is the answer not in the manual?
General| Brand | Ametek |
|---|---|
| Model | Sorensen XG 33-25 |
| Category | Power Supply |
| Language | English |
Provides a summary of the essential steps required for installing the power supply.
Describes the procedures and safety precautions for connecting the AC input power.
Offers recommendations for selecting appropriate load wires based on current carrying capacity.
Outlines the functional tests to perform after installation to verify proper operation.
Describes how to properly connect loads to the DC output terminals of the power supply.
Explains the procedure for connecting remote sensing wires to the load for accurate voltage regulation.
Details the three operating modes: Constant Voltage, Constant Current, and Constant Power.
Explains the various alarms and error conditions that can occur and their precedence.
Details the Over Voltage Protection feature and its configuration for load safety.
Provides detailed steps for configuring remote control via the RS-232 serial interface.
Guides on setting up remote control using the USB interface and installing necessary drivers.
Explains gain error and offset error as sources of analog programming error.
Provides the procedure for calibrating the gain of the voltage and current outputs.
Provides the procedure for calibrating the offset of the voltage and current outputs.
Details the process for calibrating the output voltage, including gain and offset adjustments.
Details the process for calibrating the output current, including gain and offset adjustments.
Describes the procedure for calibrating the Over Voltage Protection (OVP) setting.
Provides guidance for operators on troubleshooting common issues and symptoms.
Explains how errors are placed in a queue and how the error queue is cleared.
Lists IEEE 488.2 syntax errors detected by the instrument's parser, including error codes and descriptions.
Details errors detected by the instrument's execution control block, including parameter and setting conflict errors.
